Difference between revisions of "Viewing results of an array calculation"
Davidpaine (talk | contribs) |
Davidpaine (talk | contribs) |
||
| Line 7: | Line 7: | ||
<!--I don't know what this is supposed to do so I'm commenting it out[DP]*Select 'Miles per year'. | <!--I don't know what this is supposed to do so I'm commenting it out[DP]*Select 'Miles per year'. | ||
<small>Note that it is defined as scalar 12K</small>--> | <small>Note that it is defined as scalar 12K</small>--> | ||
| − | *Bring up result table of 'Fuel cost'. | + | *Bring up result table of 'Fuel cost'. Result should be as shown |
[[Image:Chapter 5.PNG]] | [[Image:Chapter 5.PNG]] | ||
*Go back to the top level diagram. | *Go back to the top level diagram. | ||
| − | *Bring up result table of 'Maintenance cost'. | + | *Bring up result table of 'Maintenance cost'. Check the results: |
| − | |||
[[Image:Chapter 5 maintenance.PNG]] | [[Image:Chapter 5 maintenance.PNG]] | ||
Revision as of 09:03, 3 July 2013
Result view of Miles per gallon is in focus
- Close result window
- Return to Fuel cost Module diagram
- Bring up result table of 'Fuel cost'. Result should be as shown
- Go back to the top level diagram.
- Bring up result table of 'Maintenance cost'. Check the results:
- Select 'Total cost' and bring up its result table. Your result table would show that it is indexed by Car type:
Small car: 476 + 1200 = 1676 Large car: 714 + 2400 = 3114
Comments
Enable comment auto-refresher